Dolphin Pool Cleaner Power Supply Got Wet

Introduction:

A day of relaxation by the pool can quickly turn into a stressful situation when you find out that your Dolphin pool cleaner’s power supply has gotten wet. But don’t worry; in this guide, we’ll walk you through the steps to assess the damage and, if possible, salvage your pool cleaner.

Safety First: Disconnect the Power:

Before you do anything, ensure your safety by disconnecting the power supply. Unplug it from the electrical outlet or turn off the circuit breaker that supplies power to the cleaner. This precautionary step will prevent any electrical mishaps while dealing with the wet power supply.

Remove the Power Supply from the Water:

If the power supply is still in the water, carefully remove it immediately. The longer it stays submerged, the greater the chances of extensive damage. Dry off any visible water on the surface using a clean, dry cloth.

Inspect for Water Damage:

After removing the power supply, inspect it closely for any signs of water damage. Look for water inside the casing, visible corrosion on metal components, or a burnt smell, which may indicate electrical issues. In case you have any of those symptoms, it’s important to proceed with a warning.

 Let It Dry Thoroughly

To attempt to salvage the power supply, you’ll need to let it dry completely. Place it in a dry and well-ventilated area for at least 48 hours. Avoid using heat sources like hairdryers or ovens, as excessive heat can cause further damage.

 Check for Functionality:

Once the power supply has dried, cautiously test it to see if it still functions. Plug it into a GFCI (Ground Fault Circuit Interrupter) outlet, which offers extra protection against electrical hazards. If the power supply works without any issues, you’re in luck. However, if there are still problems or if you’re uncertain, it’s best to consult a professional technician.

 Consider Preventative Measures

To prevent future incidents, consider taking precautionary measures. Ensure your pool cleaner’s power supply is placed in a location that’s protected from splashes or rain. You can also invest in a weatherproof cover for added protection.

Conclusion

Discovering that your Dolphin pool cleaner power supply got wet can be a source of concern, but by following these steps, you can increase the chances of salvaging it and getting your pool cleaner back in action. Always prioritize safety and, when in doubt, consult a professional to avoid any electrical hazards.

Understand that water and energy don’t mix, so it’s important to be cautious and take preventative measures to keep your pool purifier and its power supply dry and in properly operating condition.